Level up your Car Room game with my Tyre drawer/dresser knobs!
Shrinking down my realistic tyre signs into cute drawer knobs was too cute an idea not to do! They're very simple to install, I provide a screw with each one, you'll just need a Phillips screwdriver.
APPROX DIMENSIONS:
The tyres are 5cm/2inch wide circle, 1.5cm thick. Designed to be a little smaller than my other knobs for those awkward to fit places.
The section of the drawer where the knob and screw clamp together must be between 3-18mm (most drawers will fall within this, but please double check if you are unsure)
The hole on your drawers that the screw needs to pass through must be between 4-7mm (again, this should work with most drawers)
The design uses a standard screw instead of a typical drawer bolt. This allows the screw to create its own thread for a more secure fitting - instructions included explain all of this simply for you. There may be some small traces of glue residue on the rear side of the knob from the assembly process, this ensures they are robust, and does not affect their performance.
