Upcycled 3D Waste “Prune Your Own Tree” Eco-Friendly DIY Craft Kit | Sensory Play Desk Decor | Handmade Waste-to-Art Sculpture

Scratch your OCD itch whilst saving a turtle at the same time!

* Please note, whilst sharp scissors will cut through most of the thin sections, something like a pair of flush cutters or snips, may be useful if you need to cut through a thicker section *

The multicolour 3D printing process produces an enormous amount of waste (playfully called ‘poops’), these little poops essentially end up in a landfill, and I hate to waste things, so I decided to make them into trees. Then, whilst trimming one of the trees, I realised how oddly therapeutic shaping an upcycled plastic tree was! So I’m here to pass on the joy to you with my ‘Prune Your Own 3D Poop Upcycled Eco-friendly Tree’ kit - rolls right off the tongue.

Despite its rugged appearance, each tree is meticulously made with care and attention. I spend over 3 hours assembling each one, from gluing the colourful filament scraps into a sturdy and vibrant foundation for you to trim, to 3D printing the tree trunk and base for a professional finish. 

So what do you get?

- ONE ‘Prune Your Own Tree'  featuring a colourful messy filament ball and a 3D-printed base and trunk.

- An extra bag of colourful poops for if you need to fill any gaps or would like to expand your tree (you can push them into gaps but a glue gun or superglue is advised)

- Instructions to guide you through the pruning process and inspire your creativity.

- The joy of knowing there’s less plastic in the sea to potentially end up in a turtle’s nose or something. 

Why You’ll Love It:

Finished tree is around 20cm tall.

Oh, I also sell poop emoji prints, made out of poops, go check them out if you’re into saving the world like a good human.